Skip to content
Free UK Mainland Delivery for Orders Over £99 - Need some advice? Talk to the team on 0151-236-7800
Free UK Mainland Delivery for Orders Over £99

Full Fat Audio FFA-8004 G2 DSP Power Amp

£4,944.00 inc. vat
£4,120.00 ex. vat
Please contact us for availability.

Full Fat Audio FFA-8004 G2

The Full Fat Audio FFA-8004 G2 DSP is a completely new amplifier design from FFA the features DSP amplifier's that provide a cost effective solution for sound system design. There are 6 analogue audio output channels - 4 assigned to the FFA-8004 power amplifier and 2 assigned to a pair of male XLR connection on the rear panel of the amplifier.

These extra processed outputs could be used to design a 3 way stereo system of bass, mid and high frequency where the 2 outputs drive a 2 channel bass amplifier or used as a 2 channel DSP for any signal that requires control. The DSP features a broad band input compressor and 2 stage output signal limiter. The signal limiting allows precise system protection or contains environmental noise.

The DSP is fully password protected and has options to disable functionality. This gives the designer a tool to keep interference from unauthorised persons whom may change parameters which could either damage the loudspeaker system or exceed set environmental noise levels.

Full Fat Audio FFA-8004 G2 Features

  • Exceptional sound quality
  • High Power efficiency and cool running
  • Rugged Tour class Aluminium construction
  • Light weight - 10 kg
  • FFA Class D PWM
  • High current switch mode power supply designed to give continuous power
  • Superb limiter
  • 4 XLR analogue audio inputs
  • Neutrik® powerCON power input
  • PSU soft start
  • Hand built & designed in Hertfordshire, England
  • 5 year factory warranty


  • Power Ratings: FFA - 8004 G2 DSP - 4 x 1000W 8 Ohm, 4 x 2000W 4 Ohm
  • Gain: 32 dB
  • THD: Typical 0.05 4 Ohm 1kHz THD+N
  • Frequency Response: 20Hz - 20kHz +- 0.5dB
  • Controls: 40 Point Potentiometer per channel, power on switch
  • Indicators: signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up
  • Load Protection: DC on output, side chain TCA clip limiter circuit
  • Amplifier Protection: Short circuit, current overload, thermal shutdown, high frequency stability circuit
  • Audio Signal Inputs: Balanced Neutrik® Female XLR input connected Pin 1 - GND, Pin 2 - Hot +, Pin 3 - Cold - . XLR Male signal throughput each channel
  • Audio Signal Outputs: Neutrik® speakON each channel. Channels 1 and 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system for example stage monitor system
  • Power Requirement: 1 x Neutrik® 20A powerCON connector 1 x 16A 230 VAC Circuit. Power range 185V-230VAC, 120V (configured at factory)
  • System Cooling: High CFM 80mm fan with proportional signal speed control. Rear to front airflow
  • Dimensions: 88mm Height x 483mm Width x 510mm Depth. Includes rear rack support. 19" rack mount enclosure
  • Weight: 10 kg