DPA 3511ES - 4011ES Stereo Kit

DPA 3511ES - 4011ES Stereo Kit

The DPA 3511ES Stereo Kit is a versatile, compact piano kit, which is tailored specifically to accommodate the need for clean sound and anchored placement.

DPA have collected their award-winning recording microphones in specialized stereo kits that contain the mics and accessories you need to capture fantastic sound no matter what your need. All kits are matched within either ±0.5 dB or ±1 dB depending on the kit you choose.

This is a complete stereo kit with two compact 4011ES Cardioid Microphones, with active side cables. The mics are carefully factory-matched within ±1 dB on frequency response and sensitivity in the microphone’s entire frequency bandwidth. The kit includes mics, windscreens, holders, clips, and much more.

Ideal for unobtrusive spot miking, such as hanging or table use, the 4011ES Cardioid Microphone, Active Cable is an ultra-compact cardioid microphone from our modular recording mic series. The mic has a length of only 3.5 cm (1.4 in) and a low-key appearance.

Features

• Ultra-compact spot or hanging mic
• Close-miking
• Great for high sound pressure levels
• Accurate sound
• Colorless sound
• Modular flexibility

Specifications

• Directional pattern: Cardioid
• Principle of operation: Pressure gradient
• Cartridge type: Pre-polarized condenser
• Effective frequency response: 20 Hz - 20 kHz
• Frequency range, ±2 dB, at 30 cm (11.8 in): 40 Hz - 20 kHz
• Sensitivity, nominal, ±2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
• Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
• Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB
• Distortion, THD < 1%: 136 dB SPL RMS, 139 dB SPL peak
• Dynamic range: Typ. 121 dB
• Max. SPL, THD 10%: 144 dB SPL peak
• Rated output impedance: 100 Ω
• Minimum load impedance: 2 kΩ
• Cable drive capability: 100 m (328 ft)
• Output balance principle: Impedance balancing
• Common mode rejection ratio (CMRR): > 40 dB
• Power supply (for full performance): 48 V Phantom power (± 4 V)
• Current consumption: 3.5 mA
• Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Color: Matte black
• Weight: 109 g (3.8 oz)
• Microphone diameter: 19 mm (0.75 in)
• Capsule diameter: 19 mm (0.75 in)
• Microphone length: 35 mm (1.38 in)
• Maximum output voltage, RMS: 2.2 V
• Polarity: +V at pin 2 for positive sound pressure
• Temperature range: -40°C to 45°C (-40°F to 113°F)
• Relative humidity (RH): Up to 90%
• Matching tolerance (frequency response and sensitivity): ±1 dB
• Phase deviation for kit: < 10°