DPA ST4011A - d:dicate™ 4011A Stereo Pair with Clips and Windscreens in Peli Case
£2,560.00 ex. vat
DPA ST4011A - d:dicate 4011A Pair
The DPA d:dicate ST4011A is a stereo matched pair of cardioid directional condenser microphones packaged in a durable, solid Peli case.
With two, finely matched, first order cardioid capsules, the DPA reference standard tolerances are tuned even further to perfectly harmonise both mics to each other. Brilliant for use on drum kits, choirs, pianos, orchestras and other dynamic and varied sound sources, the 4011As offer honest, transparent sound on whatever source they focus on. High SPL handling of up to 159dB without distortion, low noise-floor and linear frequency response both on and off axis makes the pair perfect for AB stereo recordings,
The pair comes encased in a solid Peli case for transportation, and all relevant clips and windscreens are included.
DPA ST4011A Stereo Pair Features
- World-wide cardioid reference mic
- Handles very high sound pressure levels
- Carefully matched within ±1 dB
- PeliTM Case transportation and protection
DPA ST4011A Specifications
- Directional pattern: Cardioid
- Principle of operation: Pressure gradient
- Cartridge type: Pre-polarized condenser
- Frequency range: 20 Hz - 20 kHz
- Frequency range, ± 2 dB, at 30 cm: 40 Hz - 20 kHz
- Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
- Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
- Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB setting)
- S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 76 dB(A)
- Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
- Dynamic range: Typ. 121 dB
- Max. SPL, peak before clipping: 159 dB
- Switchable attenuator: 0 dB / -20 dB
- Output impedance: < 200 ohm
- Minimum load impedance: 2 kohm
- Cable drive capability: 100 m (328 ft)
- Output balance principle: Impedance balancing with Active Drive
- Common Mode Rejection Ratio (CMRR): > 60 dB
- Power supply (for full specifications): 48 V Phantom power (± 4 V)
- Current consumption: 2.8 mA
- Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Color: Matte black
- Weight: 158 g (5.6 oz)
- Microphone diameter: 19 mm (0.75 in)
- Capsule diameter: 19 mm (0.75 in)
- Microphone length: 170 mm (6.7 in)
- Output voltage, RMS: > 5 V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
- Relative Humidity (RH): Up to 90%
- Matching tolerance: ± 1 dB
- Phase deviation for kit: < 10°