Full Fat Audio FFA-2004 HD G3 DSP Power Amp4 x 500W 4 Ohm

Full Fat Audio FFA-2004

The Full Fat FFA-2004 HD G3 DSP amplifier's provide a cost effective solution for sound system design.Ideal for permanent installation or temporary sound. The DSP software has been designed to be functional and quick to use and has a familiar feel to that of a mixing console. The software runs on all platforms - PC or MAC/ IPAD based software. The DSP is accessed by Neutrik Ethercon and connected using an Ethernet network direct to a personal computer (MAC/ IPAD or PC) or via an Ethernet Hub or wireless router.

The DSP has 4 analogue audio input’s or 1 pair of selectable AES/EBU digital inputs. There are 6 analogue audio output channels - 4 assigned to the FFA-2004 power amplifier and 2 assigned to a pair of male XLR connection on the rear panel of the amplifier. These extra processed outputs could be used to design a 3 way stereo system of bass, mid and high frequency where the 2 outputs drive a 2 channel bass amplifier or used as a 2 channel DSP for any signal that requires control.

Full Fat Audio FFA-2004 Features

• Exceptional sound quality
• G3 DSP option
• Mains power efficient and cool running
• Rugged Tour class Aluminium construction
• Light weight - 9 kg
• FFA Class D PWM
• High current switch mode power supply
• Superb limiter
• 4 XLR analogue audio inputs
• 4 XLR parallel outputs.
• Bi amp Neutrik® speakON outputs
• Signal Link through
• Neutrik® powerCON power input
• PSU soft start
• Hand built & designed in Hertfordshire, England
• 5 year factory warranty

Specifications

• Power Ratings: FFA - 2004 - 4 x 250W 8 Ohm load, 4 x 500W 4 Ohm load, 4 x 1000W 2 Ohm load
• Gain: 32 dB
• THD: THD Typical 0.03 4 Ohm 1kHz THD+N
• Frequency Response: 20Hz - 20kHz +- 0.5dB
• Controls: 40 Point Potentiometer per channel, power on switch
• Indicators: signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up
• Load Protection: DC on output, side chain TCA clip limiter circuit
• Amplifier Protection: Short circuit, current overload, thermal shutdown, high frequency stability circuit
• Audio Signal Inputs: Balanced Neutrik® Female XLR input connected Pin 1 - GND, Pin 2 - Hot +, Pin 3 - Cold - . XLR Male signal throughput each channel
• Audio Signal Outputs: Neutrik® speakON each channel. Channels 1 and 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system for example stage monitor system
• Power Requirement: 1 x Neutrik® 20A powerCON connector 1 x 16A 230 VAC Circuit. Power range 185V-230VAC, 120V (configured at factory)
• System Cooling: High CFM 80mm fan with proportional signal speed control. Rear to front airflow
• Dimensions: 88mm Height x 483mm Width x 510mm Depth. Includes rear rack support. 19" rack mount enclosure
• Weight: 9 kg