Quested SB10RDM - Remote powered dual mono sub 2 x SB10R and 1 x remote power SBC250

Quested SB10RDM - Remote powered dual mono sub

The Quested SB10RDM are dual mono subs that are remotely powered using a SBC250 remote. Delivering a clean bass response as low as 25Hz, the SB10R provides the powerful bass you need. The SBC250 controller allows you to easily integrate the sub with any system.

Features

• 10" Driver
• Variable Crossover from 40Hz to 135Hz
• Gain control from -14db to +6db
• Up to 160 degrees of phase control
• Polarity Switch
• Output level metering
• Bypass function
• 1U rack unit

Specifications

SB10R

• Dimensions: Cabinet 600(w) x 332 (h) x 300(d) mm SBC250 Controller – 1U case 270mm deep
• Weight:
• Cabinet – 19.8 kg / 43.4 lb
• SBC250 Controller – 5.5 kg / 12 lb
• Drivers: Bass cone 1 x 250mm (10”)
• Frequency Response: User Adjustable. 25 Hz-200 Hz ± 2 dB / 17 Hz-200 Hz -6 dB
• Maximum SPL: 110 dB continuous pink noise @ 1 m LEQ 1 min
• Connector: 2 off XLR and ¼ inch jack combo socket
• Impedance: 10k W electronically balanced with RF filters
• Wiring:
• Pin 1 ground Sleeve
• Pin 2 hot Tip
• Pin 3 cold Ring
• OUTPUTS: 
• Left and Right Monitor 2 off XLR type male left right outputs
• Impedance 100 ohm electronically balanced
• Wiring Pin 1 ground, Pin 2 hot, Pin 3 cold
• Sub Bass Output: 1 pair binding posts
• FILTERS: Left & Right Input Summed to Sub Output
• Subsonic/High Pass: -3dB @ 14Hz, 24dB/oct or -3dB @ 28Hz, 24dB/oct (set by internal jumper)
• Low Pass: -3dB @ 40Hz to 135Hz, externally adjustable @ 24db/oct or full range on CH A
• Left & Right Input to Left & Right Output
• Ultrasonic: -1dB @ 100k
• High Pass: -3dB @ 40Hz to 135Hz, externally adjustable @ 24db/oct or full range on CH A

SBC250

• THD
• 210W rms continuous
• 0.03% at levels up to 1dB below clip, 20Hz – 120Hz typ
• 0.005% @ 20W rms 100Hz
• Hum & Noise: -100 dB referred to clip
• POWER REQUIREMENTS:
• Set by internal plug: normal 115V or 230V setting:
• Min 160V (restricted output power):
• Max 255V 115V setting:
• Min 80V (restricted output power):
• Max 127V