Schoeps CMC 1 U Miniature Microphone Amplifier, incl. SG 20, premium case.

Schoeps CMC 1 U Miniature Microphone Amplifier, incl. SG 20, premium case.

The Schoeps CMC 1 is a new, small Colette microphone amplifier, about one-third the length and 53% lighter than the CMC 6. It is compatible with all components of the Colette system and can be used in place of the CMC 6 without compromise, for all applications in which the size and weight of the microphone play a role.

At SCHOEPS, “uncompromising miniaturization” means that the electrical characteristics of the CMC 1 are equal to, or even better than, those of the CMC 6. Through modern electronic design, these outstanding electrical properties have been achieved:

• high maximum SPL: 135 dB-SPL with the MK 4 (0.5% THD or less)
• very low current consumption: 2.0 mA at 48 Volts
• operates on 48 V or 12 V phantom power, reliable operation even if powering is somewhat marginal
• very high immunity from RF interference with the SCHOEPS RFI Shield; high immunity to cable-induced hum and other interference (field tested with Audio Limited A 10, etc.)
• flat frequency response
• very low distortion constant output impedance across the audio frequency range
• balanced, direct-coupled, class-A output circuit
• output is filtered in the ultrasonic range to prevent interference, e.g. from camera autofocus

A complete Colette-series microphone consists of an MK capsule and a CMC amplifer. All capsules and active accessories of the Colette system are compatible with the CMC 1.

The CMC 1 works with standard 12-Volt or 48-Volt phantom powering. Power consumption is lower at 12 Volts--an advantage for battery-powered operation

Features

• Variant of the CMC 1 U with miniature Lemo output connector
• K 5 LU (5 m cable with XLR-3M plug) and SGC stand adapter are included
• Fully equal alternative to the well-known CMC 6
• Compatible with all available MK capsules and active Colette accessories, e.g. CUT 60 or RC
• Compatible with all accessories of the CCM series, e.g. TR L oder STA
• Recommended accessories for boom use are the same as for CCM microphones, e.g. MINIX CCM LU or Rycote INV-5.

Specifications

• Frequency range
• 20 Hz-20 kHz
• Sensitivity
• see corresponding capsule
• Maximum output voltage
• 1,8 V (5 dbV) with 1kΩ load
• Maximum sound pressure level (THD < 0.5 %)
• 135 dB-SPL (P48) with MK 4
• 131 dB-SPL (P12) with MK 4
• Low cut filter
• 20 Hz, 12dB/oct
• Output impedance
• 50 Ω +/- 1 Ω (8 Hz - 50 kHz)
• Minimum recommended load impedance
• 1 kΩ
• Common mode rejection ratio (at 1 kHz)
• > 55 dB
• Maximum cable length
• > 400 m / ~1300 ft
• SCHOEPS RFI Shield
• Yes
• Powering standard / Valid range
• P48 / 30-52 V
• P12 / 11-13 V
• Current consumption
• 2mA (P48)
• 3 mA (P12)
• Output
• Lemo, analog, 1 channel
• Length
• 25.5 mm / ~1 ''
• Diameter
• 20 mm / 0.8''
• Weight
• 28 g / ~1 oz