Sonifex AVN-PM8

The Sonifex AVN-PM8 is a powerful audio interface capable of audio routing, metering and equalisation. The AVN PM8 features both physical I/) and AES67 stream I/O and can mix and route freely from any input to and output which is useful for a multitude of applications.

Features

8 x mic/line inputs and 8 x stereo line outputs on D-type sockets with AES59 analogue pinout, paralleled with 8 x RJ45 connectors using StudioHub® pinout.
‘T’ version has audio I/O on terminal blocks.
‘D’ version has input & output metering.
+48V phantom power per input with red LED indications.
Mic pre-amp gain adjustment.
Input/output gain/trim.
Responsive webserver software router/mixer.
Up to 8 AoIP input streams with a maximum of 16 channels to be routed.
Up to 8 AoIP output streams with a maximum of 8 channels each (i.e. 64 channels).
Dual 1Gb Ethernet & 1Gb SFP port.
Dual AC & DC power supply inputs.
10 user assignable GPIO ports.

Webserver Software

A built-in responsive web server provides complete remote configuration & control of the unit including matrix mixing and routing, and also allows for firmware updates and configuration backup. Complete product configurations can be saved and loaded for use in different situations and system logs can be saved for device information.

Mix Matrix

The key to the success of the AVN-PM8 is the mix matrix where physical inputs can be freely mixed and routed with AES67 streams, in a simple and intuitive way to both physical outputs and AES67 streams.

The unit can stream RAVENNA & AES67 AoIP streams or AES67-enabled Danteï¿½ flows (discovered using SAP). It can receive AoIP streams from 16 additional AES67 sources and can send to 64 additional AoIP destinations.

Input and output AES67 streams can be individually added/modified and the SDP of each stream can be checked and edited.

DSP functions, such as gain and filtering, can be added at inputs, outputs and cross-points. The unit can act as a PTP masterclock or slave clock and supports IEEE1588-2008 PTPv2 media and default profiles.

Front Panel Displays, Metering & Controls

The AVN-PM8 can be supplied with different front and rear panels. As standard it has a front panel display to show product information and it uses XLRs and RJ45s for rear panel connectivity.

Using an OLED display, the front panel provides detailed status information on device name, network addresses, PTP clocking info, power status/voltages and version information. The display and navigation controls allow editing of certain functions, limited to networking (IP addresses, friendly name, etc) and display (brightness and contrast). The front panel controls also include user configurable buttons which can be set-up to perform actions such as activating a GPIO or as a shortcut button to jump to a specified menu on the OLED display.

Front panel LEDs show the AoIP network status, synchronisation status and the status of the AC and DC power supply inputs. The brightness of the OLED display and LED indicators can be continuously adjusted for low or high lighting conditions.

A front panel power button is available to turn the unit on and off. The power button is disabled by default but can be enabled through the ‘Display Settings’ web page.

Detailed Metering Option

The ‘D’ version of the portal (e.g. AVN-PM8D) has two bright TFT meter displays which provide a live display of the levels of the physical inputs and outputs respectively. A rotary navigation control can be used to select a single input or output and view its metering data in a more detailed horizontal view.

The metering scale used is user configurable to one of 9 different metering scales, with relevant ballistics. The metering scales available are: Dual PPM + Standard VU, EBU PPM, BBC PPM, Nordic PPM, AES Digital PPM, DIN PPM, German PPM, SMPTE RP.0155, Standard VU & Extended VU.

Metering can be set to be either ‘Discrete’ or ‘Continuous’, which changes the appearance of the meter bar. Phase metering can be displayed per stereo output channel and channel idents can be shown either above or below the metering to identify each input/output.

On devices without a meter display, a smaller set of monochrome meters are shown on the main OLED display.

Physical Inputs & Outputs

For the microphone audio, the AVN-PM8 uses 8 x mic/line XLR sockets for the inputs and 8 x RJ45 connectors using StudioHub® pinout for the stereo analogue line outputs. +48V phantom power is available for each microphone input with a red LED presence indication.

The ‘T’ version (e.g. AVN-PM8T) uses rear panel terminal block connectors for all physical inputs and outputs.

The rear panel contains IEC mains and secondary DC power inputs which provide power redundancy to the product.

There are two Ethernet RJ45 connections (control and AoIP) and there is an Ethernet SFP module that, when used, replaces the AoIP RJ45 connection, e.g. for a 1Gbit/s copper or optical SFP transceiver. When an SFP is used, this replaces the AoIP RJ45 connection.

A rear panel GPIO connector provides 10 local ports which can be user configured as inputs or outputs and provide software-controlled functionality. A voltage free relay contact can be used to operate external equipment. There are virtual GPIO ports which can be used to trigger events over the network between devices.

For remote operation and monitoring, SNMP V2 is supported and the units can be controlled using Ember+ commands.

8 Way Analogue Headphone Distribution System

The AVN-PM8 can be combined with multiple AVN-HA1 headphone amplifiers to provide a headphone distribution system – the portal output connections can supply analogue power to satellite headphone amplifiers.

The AVN-PM8 can be combined with multiple Sonifex AVN-HA1 headphone amplifiers to provide 8 separate headphone signals where each headphone amplifier can be sent a separate feed, mixed from any physical mic input or stream input. On portal units with RJ45 outputs, an AVN-HA1 headphone amplifier can be used to listen to the outputs, with the portals providing power and audio signals. The switches on the front panel of the AVN-HA1 can be used as another GPI for muting the output.

Applications

8 channel microphone input mixer, with individual output gain control, input/output metering and AES67 stream generation.
8 channel clean-feed generator, with input mixing and gain control on inputs and outputs.
Distribute 8 microphone channels of audio over an SFP fibre connection.
IFB generator to send 64 x AES67 streams to individual belt-packs.
8 output headphone distribution system, with separate input mix for each headphone output and individual gain control.
Input mixer with input/output metering and stream AES67 generation.

Specifications

Audio-Over-IP Specification

Open Standards: RAVENNA, AES67
Device Discovery: Bonjour (mDNS / DNS-SD) or SAP
Audio Delivery: RTP/UDP over IPv4 multicast
QoS: DiffServ
Stream Management: RTSP/SDP
Control: Web server/Ember+
Format: Linear PCM 24-bit (L24)
Channels Per Stream: Up to 8
Frames Per Packet: 48
Transmit Streams: Up to 8
Sample Rate: 48 kHz

Ember+ Interface Connection

Interface Type: Provider
Network Interface: Ethernet port and AoIP port
Port: 9000

Timing Synchronisation

Profile Support: Default, AES67 Media & Custom profiles
Timing Protocol: PTPv2, IEEE1588-2008

Microphone Inputs

Input Impedance: > 2.5kΩ balanced
Gain Range: 0dB to +60dB
0dBFS Line-Up: Adjustable in steps of 3dB from -58dBu to +2dBu
Frequency Response: 20Hz to 20kHz, +0/-0.2dB
Noise: -127dBu, 20kHz BW, Rs=200Ω ref. 76dB gain

Balanced Line Inputs

Input Impedance: > 20kΩ balanced
0dBFS Line-Up: Adjustable +15/+18/+20/+22/+24dBu
Frequency Response: 20Hz to 20kHz, +0/-0.2dB
THD+N: < -110dBFS, -30dBFS, 20Hz to 20kHz, 20kHz BW
Noise: -110dBFS, 20kHz BW, Rs=200Ω
Crosstalk: < -100dB

Common Mode

Rejection: > 70dB @ 1kHz

Balanced Line Outputs

Output Impedance: < 50Ω balanced
0dBFS Line-Up: Adjustable +15/+18/+20/+22/+24dBu
Frequency Response: 20Hz to 20kHz, +0/-0.2dB
THD+N: < -110dBFS, -30dBFS, 20Hz to 20kHz, 20kHz BW
Noise: -110dBFS, 20kHz BW, Rs=200Ω

Connections

Inputs: XLR connectors with phantom power (toggle).
Outputs: RJ45 connections (StudioHub+ pinout).
GPIO: 1 D-Sub (DA-15) connections.
Network

2 x Gigabit Ethernet, RJ45’s.
1 x SFP fibre.

Power: Mains AC Input: Universal filtered IEC, continuously rated 85-264VAC, 47-63Hz, 20W.
DC Input: 4-pin 7.5A power jack socket, 10-14VDC.
Fuse Rating: Anti-surge fuse 2A 20mm x 5mm.

Equipment Type

AVN-PM8: Advanced audio routing, metering and equalisation unit with analogue mic/line inputs, analogue outputs, and RAVENNA AoIP.

Physical Specification

Dimensions (Raw): 48.3cm (W) x 17.5cm (D) x 4.4cm (H)(1U)
19” (W) x 6.9” (D) x 1.8” (H) (1U)
Dimensions (Boxed): 55.5cm (W) x 29cm (D) x 18cm (H) 22” (W) x 11.4” (D) x 7” (H)
AVN-PM8: Weight: Nett: 2.98 kg Gross:4.02 kg

Filters

Sonifex

Sonifex AVN-PM8 - 8 Mic/Line Inputs, 8 Stereo Line Outputs, AES67 Portal