Rupert Neve Designs 543 - 500 Series Compressor
£857.50 ex. vat
Rupert Neve Designs 543
The Rupert Neve Designs 543 is a 500 series mono compressor designed to deliver the unobtrusive, musical-sounding dynamic control and brick-wall limiting made famous in the Portico 5043 to the 500 series format. The RND 543 features a fully controllable compressor-limiter with feed-forward / feedback modes, Peak / RMS detection and a built in side chain high pass filter. With an unrivaled heritage and a tremendous feature set, the 543 yields a combination of rich warmth, flexibility and precision that is sure to resonate in the ears of sound engineers the world over.
Rupert Neve Designs 543 Features
For signals below the “threshold” level that has been set, a compressor provides a linear path allowing signals to be amplified without the gain being adjusted in any way. When signals exceed the “threshold” level, the gain is reduced in a controlled manner that depends on the Ratio that has been set.
GAIN range provided is from -6dB to +20 dB. As already noted, when compression has taken place, it may be necessary to increase the overall gain to restore the apparent program level
When engaged, the 543 uses a combination of peak and RMS (average) detection to determine level. When disengaged, it follows just RMS.
Introduces a HPF at 250Hz to the VCA side chain signal. This allows the compressor to disregard sustained low frequency content.
Range from 1:1 to LIMIT (i.e. 40:1)
Range from -30dBu to +20dBU
Range from 20 mS to 75 mS.
Release / Recovery Time
Range of RELEASE time is 100 mS to 2.5 Seconds.
When the LINK switch is engaged on two 543 modules and settings are approximately the same values, GAIN reduction on both channels will be the same to preserve stereo balance and position. This will work properly in link buss enabled 500 series racks, or by hardwiring two 543 modules link busses together in non-compatible racks.
When the LINK switch is engaged on two connected 543 modules, the signal passing through the first module may be used to control the amplitude of a second module. For example, the level of music through channel A can be controlled by speech on channel B, i.e. reducing the music level to make a “speech-over” announcement.
Two Peak LED METERS are provided that show OUTPUT LEVEL and GAIN REDUCTION. Output level meter covers the range from -10 to +22 dBu and above which is regarded as overload. REDUCTION is calibrated in dB covering the range +1 to 22 dBu, reading from right to left,
- Gain Range: Continuously variable from 6 dB to +20 dB.
- Threshold Range: Continuously variable from 36 dB to +22 dB.
- Ratio Range: Continuously variable from 1.1:1 to Limit (40:1).
- Attack Range: Continuously variable from 20mS to 75mS
- Release Range: Continuously variable from 100mS to 2.5 Seconds.
- FF/FB: Feed-Forward or Feed-Back VCA control.
- Frequency Response: 18 Hz to 150 kHz -3 dB.
- Crosstalk: Better than 90 dB @ 15kHz.
- Total Harmonic Distortion and Noise: @ 1kHz, +20 dBu output level, no load.